14
PART 2 • English
7.2 Installation
7.2.1 Auto Scan
Use pq to select Installation and press OK or u to advance.
Select Auto Scan with pq and press OK to enter.
Use tu to toggle between FTA Only Yes and No. When FTA Only is set to Yes, scrambled channels
won’t be stored in the channel list. Use pq to highlight Search. Now press OK to start auto scan.
The receiver will store all newly found channels in the channel list.
7.2.2 Channel Scan
Use pq to select Installation, press OK or u to advance.
Use pq to select Channel Scan and press OK to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No. If By Frequency
is selected, use the cursor buttons to select Frequency and Bandwidth. Highlight Search and press OK
to start scanning. Newly found channels will be stored in the channel list.
7.2.3 Aerial Adjustment
Use pq to select Installation, press OK or u to advance.
Use pq to select Aerial Adjustment and press OK to enter.
Use pq move the highlight to the setting you wish to alter and use tu to change values.
The following settings are available:
Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present on
the ANT IN connector of the receiver. Select Off for passive antennas.
Beeper: Select On for an audible indication of signal reception. Off turns the beeper
off.
Channel No.: Select a channel that is known to carry broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
Press EXIT to leave the Aerial Adjustment screen.
7.2.4 LCN (Logical Channel Numbering)
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator,
channels will be stored in an operator defined order. Set LCN to On to activate operator defined
channel numbering or Off to store channels in found order.
7.3 System Setup
This menu allows you to manage the system settings of your receiver. It consists of the following
sub-menus: Language, TV System, Local Time Setting, Timer Setting, Conax Conditional Access, Parental
Lock, OSD Setting, Favourite and Auto Standby.
Press pq to highlight a menu and press OK advance to the next screen. Use pq to move the
highlight to a setting. Values can be changed with tu. Press EXIT to leave.
To Next Page
Loading...
