21
PART 2 • English
English
7.6.5 DVR Configuration
This menu allows you to make settings for Timeshift, recording and playback.
Select DVR Configuration from the Media+ menu and press OK to enter.
Use pq to move the highlight and tu to change settings.
Press EXIT to quit.
Timeshift: On or Off. When Time Shift is set to Off, Time Shift becomes inactive.
Timeshift to Record: On or Off. When set to On, Timeshift is also possible during recording.
Record Selection Select the partition whereto the receiver should record.
Standby after record: On or Off. Select if receiver should go into standby mode after a timer
recording.
Step to: 30 sec to 10 min. Set the time step you like to jump forward to with the button
3 during playback of recorded files.
NOTE: Please use a well-known brand USB 2.0 USB HDD for recording and
Timeshift. Some USB devices may not be usable due to their quality.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
Problem Possible cause What to do
LED indicator
not lit
Mains lead unplugged
Mains fuse blown
Check mains plug
Check fuse
No signal found Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power ON
or connect external power for active
antennas
No picture or
sound on TV
HDMI is not selected on your TV
or Amplifier or is set to higher
resolution as TV supports
TV is not switched on
Switch to correct TV input
Select lower resolution on receiver
Switch TV on
Scrambled channel
Message
Channel is scrambled Select alternative channel
Insert provider smartcard.
Insert smartcard with chip side down
No response to
remote
control
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
To Next Page
Loading...
