17
PART 2 • English
English
Current card level: The CA level which is currently set on the smartcard. The following levels
available in the Conax system: G-General Audience, PG – Parental Guidance,
A – Over 18 and X-Erotic. Use the pq buttons to select the Current card level
option and then use the tu buttons to change the value. Then press the OK
button. The cursor will jump to the Enter CA PIN to modify option. In order to
process the maturity rating change, you need to type the CA PIN code.
Enter CA PIN to modify: Enter the current CA PIN code with the numeric buttons.
About Conax CA: This menu provides information about the Conax system and the smartcard.
7.3.6 Parental Lock
This menu allows you to protect the installation menu and/or channels with a password. You can also
enter a new password in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press OK to proceed. You will be
asked to enter your pin code. (DEFAULT: 1234)
Menu Lock: Locks the installation menu. You can set Menu Lock to On or Off.
Channel Lock: Choose between: Off, AGE 4, AGE 5, up to AGE 18. Channels with a parental
rating above the chosen age will be protected with a password (if available in
your local broadcast.)
New Password: Enter your new password (4 digits) here.
Confirm Password: Re-enter your password here to confirm.
7.3.7 OSD Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD timeout: Sets the time after which on screen banners and messages disappear. The
range is 1~10 seconds.
OSD Transparency: To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press OK to clear all OSD settings and reset to default values.
7.3.8 Favourite
This menu allows you to personalize the names of the 8 available favourite lists.
Use pq to select Favourite from the System Setup menu and press OK to proceed. The names of
all groups are now displayed. Select a favourite group with pq and press OK to edit its name. A text
field pops up to the right of the screen. Use tu pq to select characters and enter them with OK.
When you have finished editing, press BLUE to save the changes. When all changes have been made,
press EXIT twice.
7.3.9 Auto Standby
Auto Standby is a new feature that helps you reduce power consumption. When set to On, the
receiver will turn to standby if it doesn’t receive any commands for three hours. Set Auto Standby to
Off to avoid the automatic switch down.
To Next Page
Loading...
