EN-17
Default Footswitch Controls
Function
Button Default 1 Default 2 / None Default 3
I
Function Jog Select Mode
Option(s) — Oscillate or Forward/Reverse
II
Function Select Handpiece
Option(s) RF or Shaver
III
Function Select Direction Select Speed
Option(s) Forward or Reverse High or Low
A
Function Oscillate Oscillate/Reverse
Option(s)
FIXED
xed
VAR
variable
FIXED
xed
B
Function Forward/Reverse Oscillate/Forward
Option(s)
VAR
variable
VAR
variable
FIXED
xed
Note: When using small-joint handpieces, only Default 2 settings are available. No other defaults
or user preferences can be applied.
Console Controls
Adjusting Cutting Speed
Use the adjust buttons
on the console to manually adjust the power or speed setting for
the active handpiece.
Notes:
• In shaver mode, the console uses radio frequency identication (rfid) to automatically detect
which type of disposable attachment is connected to the handpiece. Upon recognition, the
console adjusts to an optimal preset cutting speed, direction, and power.
• Forward and reverse settings are adjusted independent of each other. Adjusting settings in
one mode will not aect the other.