28
MU_CSI_982_GES_von_Palette
30.06.2017
PAGE 1 / 1
EN/09.2017/G44 © STULZ GmbH – all rights reserved
cybercool indoor chiller original instructions
Transport without fork lift
You will need scantlings of at least 1m length and a height of 150160mm.
WARNING
Risk of crushing by tipping of the unit
Select starting point for pushing not higher than 1m. Do not stay behind the unit. Wear safety
boots.
• lay the scantlings ush against the pallet and secure them against slipping.
• push the unit on the scantlings by two persons.
• put the mounting aids at the left and right unit side.
• lift the support surface of the mounting aids at a sufcient height so that the weight of the unit lies on the
mounting aids. Secure the mounting aids by belts around the unit.
• take away the scantlings from under the unit.
• drive the unit by the mounting aids to the installation site.
• drop the unit, loosen the belts and pull away the mounting aids.
NOTICE
Place the male triangular wrench in a visible location in the immediate vicinity of the chiller.
To Next Page
Loading...
