Black plate (182,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
3-60 Instruments and controls
4. Select the preferred setting by operat-
ing the “
” or “ ” switch, and then pull
the “
/SET” switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete for approximately 3
seconds.
If the setting is not available, the following
notification will be displayed for approxi-
mately 3 seconds. For more details,
contact a SUBARU dealer.
! Auto light sensor sensitivity setting
1. Perform the preparation steps accord-
ing to “Preparation for car settings” F3-56.
2. Operate the “ ” or “ ” switch to
select the “Auto Light Sensor” item, and
To Next Page
