reaches 0 km, the display will show
“0000” for the next 311 miles (500 km).
After exceeding 311 miles (500 km), “_
___” will be displayed.
! Oil filter setting
The setting procedure is the same as
“Engine oil setting” F3-67, but select the
“Oil Filter” item in step 2.
! Tires setting
The setting procedure is the same as
“Engine oil setting” F3-67, but select the
“Tires” item in step 2.
! Maintenance schedule setting
The setting procedure is the same as
“Engine oil setting” F3-67, but select the
“Maintenance Schedule” item in step 2.
! On/Off setting
1. Perform the preparation steps accord-
ing to “Preparation for maintenance set-
tings” F3-67.
2. Operate the “ ” or “ ” switch to
select the “On/Off” item. Then pull the “
/
SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select “On” or “Off” by operating the
“
” or “ ” switch. Then pull the “ /SET”
switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
Instruments and controls/Multi function display
– CONTINUED –
3-69
To Next Page
