4. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Hazard warning flasher setting
1. Perform the preparation steps accord-
ing to “Preparation for car settings” F 3-72.
2. Operate the “ ” or “ ” switch to
select the “Hazard Warning Flasher” item.
Then pull the “
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select “On” or “Off” by operating the
“
” or “ ” switch. Then pull the “ /SET”
switch toward you.
Instruments and controls/Multi function display
– CONTINUED –
3-73
To Next Page
Loading...
