Instruments and controls/Multi function display
5. Select “ Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Defogger setting
1. Perform the preparation steps accord-
ing to “Preparation for car settings” F 3-72.
2. Operate the “ ” or “ ” switch to
select the “Defogger” item. Then pull the
“
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select the preferred setting by operat-
ing the “
” or “ ” switch. Then pull the
3-74
To Next Page
