“ /SET” switch toward you.
5. Select “ Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Interior light off delay timer setting
1. Perform the preparation steps accord-
ing to “Preparation for car settings” F 3-72.
2. Operate the “ ” or “ ” switch to
select the “Interior Light” item. Then pull
the “
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
Instruments and controls/Multi function display
– CONTINUED –
3-75
To Next Page
