Instruments and controls/Multi function display
2. Operate the “ ” or “ ” switch to
select the “Keyless Access Setting” item.
Then pull the “
/SET” switch toward you.
! Driver’s door unlock setting
1. Perform the preparation steps accord-
ing to “Preparation for keyless access
settings” F3-77.
2. Operate the “ ” or “ ” switch to
select the “Driver’s Door Unlock” item.
Then pull the “
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select the preferred setting by operat-
ing the “
” or “ ” switch. Then pull the
“
/SET” switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
3-78
To Next Page
