6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Rear gate unlock setting
1. Perform the preparation steps accord-
ing to “Preparation for keyless access
settings” F3-77.
2. Operate the “ ” or “ ” switch to
select the “Rear Gate Unlock” item. Then
pull the “
/SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
4. Select the preferred setting by operat-
ing the “
” or “ ” switch. Then pull the
“
/SET” switch toward you.
Instruments and controls/Multi function display
– CONTINUED –
3-79
To Next Page
