Instruments and controls/Multi function display
3. After the selection screen is displayed,
operate the “
” or “ ” switch to show the
“Initialize” item. Then, pull the “
/SET”
switch toward you.
! Reset to factory default settings
1. Perform the preparation steps accord-
ing to “Preparation for initialization” F3-
81.
2. Operate the “ ” or “ ” switch to
select the “Reset to Defaults” item. Then
pull the “
/SET” switch toward you.
3. The system will prompt a Yes/No
dialogue (“No” is selected first). To return
to the factory default settings, select “Yes”
by operating the “
” switch.
4. Confirm the setting by pulling the “ /
SET” switch toward you.
5. The system will notify you that the
setting is complete.
3-82
To Next Page
