Black plate (151,1)
一般Model "A8140GE-A" EDITED: 2007/ 12/ 13
& Vehicle Dynamics
Control operation indi-
cator light
This light illuminates when the ignition
switch is ON and turns off approximately 2
seconds later.
It blinks when the skid suppression func-
tion is activated. It illuminates when only
the traction control function is operating.
The Vehicle Dynamics Control system is
probably faulty under any of the following
conditions. We recommend that you have
your vehicle checked at a SUBARU dealer
immediately.
. The light does not illuminate when the
ignition switch is turned to the “ON”
position.
. The light does not turn off even after a
period of approximately 2 seconds after
the ignition switch has been turned to the
“ON” position.
& Immobilizer indicator
light
This light begins flashing approximately
60 seconds after the ignition switch is
turned from “ON” position to the “Acc” or
“LOCK” position or right after the key is
pulled out. Refer to the “Immobilizer”
section in chapter 2.
If the indicator light does not blink, it may
indicate that immobilizer system is not
working properly. We recommend that you
contact your neare st SUBA RU deal er
immediately.
In case an unauthorized key is used, the
immobilizer indicator light illuminates.
& SPORT mode indicator
light (AT vehicles)
This light illuminates when the ignition
switch is turned to the “ON” position and
turns off after the engine has started.
When the selector lever is moved to the
manual gate, the SPORT mode is se-
lected and the indicator light illuminates.
Refer to the “Automatic transmission”
section in chapter 7.
& Selector lever and gear posi-
tion indicator (AT vehicles)
This indicator shows the position of the
selector lever.
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to the
“Automatic transmission” section in chap-
ter 7.
& LO position indicator
light (dual range MT ve-
hicles)
This light illuminates when Hi-Lo select
lever is set at Lo position.
Instruments and controls 3-29
– CONTINUED –
3
To Next Page
Loading...
