Black plate (270,1)
一般Model "A8140GE-A" EDITED: 2007/ 12/ 13
7-38 Starting and operating
Cruise control (if equipped)
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 40
km/h (25 mph) or more. Make sure the
main switch is turned “OFF” when the
cruise control i s not in use to a void
unintentionally setting of the cruise con-
trol.
WARNING
Do not use the cruise control under
any of the following conditions. This
may cause loss of vehicle control:
. driving up or down a steep grade
. driving on slippery or winding
roads
. driving in heavy traffic
NOTE
If you press the main switch button
while turning the ignition switch “ON”,
the cruise control function is deacti-
vated and the cruise control indicator
light flashes. To reactivate the cruise
control function, turn the ignition
switch back to the “Acc” or “LOCK”
position, and then turn it again to the
“ON” position.
& To set cruise control
1. Push the “CRUISE” main switch but-
ton.
The cruise control indicator light on the
combination meter will illuminate.
2. Depress the accelerator pedal until the
vehicle reaches to the desired speed.
3. Push the “SET/COAST” button and
release it. Then release the accelerator
pedal.
To Next Page
Loading...
