Black plate (44,1)
一般Model "A8140GE-A" EDITED: 2007/ 12/ 13
1-18 Seat, seatbelt and SRS airbags
The rear center seat belt is stowed in a
recessed compartment locate d in the
ceiling above the cargo area.
1. Remove the tongue plate from the slot
in the recessed compartment by pulling
the tongue plate rearward and pull out the
seatbelt slowly.
2. After drawing out the seatbelt, pass it
through the belt guide.
3. After confirming that the webbing is not
twisted, insert the connector (tongue)
attached at the webbing end into the
buckle on the right-hand side until a click
is heard.
If the belt stops before reaching the
buckle, return the belt slightly and pull it
out more slowly. If the belt still cannot be
unlocked, let the belt retract slightly after
giving it a strong pull, then pull it out slowly
again.
4. Insert the center seatbelt tongue plate
in the center seatbelt buckle marked
“CENTER” on the left-hand side until it
clicks.
To Next Page
Loading...
