SUMAVISION TECHNOLOGIES EMR3B - 5.2.1.1 Steps for Ethernet Port Input Setting

SUMAVISION EMR Operation Introduction
23 /53
WEB Network Management Screen
There are the following seven sub-menu:
 Status information: search the version information, status information,
input/output information of the board card;
 Board card parameter setting: Set the parameters for Ethernet port 1 and 2,
including IP address, subnet mask, gateway, speed and duplex, optical output
amplitude; after modifying the parameters, and click “Submit the setting” to finish
the operations;
 ARP parameters: Modify ARP static list and view ARP dynamic list;
 Ethernet port 1 input setting: Add the input port and other receiving parameters;
 Ethernet port 2 input setting: Same as above;
 Ethernet port 1 output setting: Add the output port and other sending parameters;
 Ethernet port 2 output setting: Same as above.
5.2.1.1 Steps for Ethernet Port Input Setting
The Network Management Input Setting screen displays the parameter information of the