9-4
9.Troubleshooting｜Error message list
9. Troubleshooting
Error message Possible cause Troubleshooting Refer to
A lip is observed on
the left (right) fiber
end.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with the
cleaver you
use.
A chip is observed
on the left (right)
fiber end.
٠
Cleave the left fiber again and
clean the cleaver.
٠
If the fiber end face is
still poor.
Please change the blade
position or replace the blade.
▸Instruction
manual that
came with
the cleaver
you use.
The splicer failed
to adjust the focus.
There is a foreign object in
the screen.
Clean the microscope lens protection
glass and LEDs.
▸P.3-2
Cleaning LEDs,
P.3-3 Cleaning
lens protection
glass
There is dust on the V-
groove and fiber clamp.
Clean the V-groove and bare fiber
pad.
▸P.3-1
Cleaning V-
grooves, P.3-2
Cleaning bare
fiber pads
There is dust on the fiber.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
Dust
OK
To Next Page
Loading...
