2-5
2. Basic splicing operation｜Preparing power supply
2. Basic splicing operation
• Before using the battery pack for the first time, charge the battery
pack. (The battery is not fully charged before shipping.)
1： Insert the battery pack into the TYPE-72C+.
2： Connect the AC adapter to the TYPE-72C+.
3： The LED (green) next to the DC input terminal blinks and the charging is
started.
4： It takes 4 hours to finish charging though the charging time differs
according to the remaining battery capacity. The LED (green) illuminates
when the charging completes.
•The battery pack can be charged while the splicer is in use. However,
it takes a longer compared with the time when the splicer is turned
off.
•Charge the battery in the following temperature range. The battery
pack might be deteriorated (decrease in capacity) at the temperature
that exceeds the range.
*Temperature range for charging: 0°C~+40°C
Insert the battery pack.
LED (green)
Connect the AC adapter.
■ Battery char
in
To Next Page
Loading...
