Sun Microsystems BLIZZARD Qtech III - Machine Setup Procedures; Refrigerant Scale Setup

To Next Page

To Previous Page

INSTRUCTIONS MANUAL

-16-

FIG. 3

SETUP

The machine is supplied fully assembled and tested.

Remove the protections under the refrigerant scales as follows:

Release refrigerant scale:

- In order to remove the protections under the refrigerant scale the screw (ref.1, Fig.3)

has to be unscrewed until it full stops

- Connect the machine to the electrical supply and switch it on

- Check if the value of refrigerant scale is correct.

Lock refrigerant scale:

NOTE: in the event that the equipment has to be transported, the refrigerant bottle scale

should be locked in place as follows:

1. Switch the machine on.

2. Tighten the screw (ref.1, Fig.3) until the display signals ZERO availability.

NOTE: Check that the oil containers are properly placed in their housing