Intro(8)
Intro 3
setdcl set a domain component list (DCL)
setdomainmode set a domain mode
setdomparam forcibly rewrite OpenBoot™ PROM environment variables
setdscp set the IP address assignments for the Domain to Service
Processor Communications Protocol (DSCP)
setdualpowerfeed set dual power feed mode
setemailreport set up the email report configuration data
sethostname set a host name and domain name for an XSCF unit
sethttps start or stop the HTTPS service, which is used in the XSCF
network. This command also performs authentication-
related settings
setldap configure the Service Processor as a Lightweight Directory
Access Protocol (LDAP) client
setlocale set the default locale of the XSCF
setlocator control the blinking of the CHECK LED on the operator
panel
setloginlockout enable or disable login lockout feature
setlookup enable or disable the use of the Lightweight Directory
Access Protocol (LDAP) server for authentication and
privilege lookup
setnameserver set the domain name system (DNS) servers used in the
XSCF network
setnetwork set or remove the network interface that used in XSCF
setntp set the NTP servers used in the XSCF network
setpasswordpolicy manage the system password policy
setpowerupdelay set the warm-up time of the system and wait time before
system startup
setprivileges assign user privileges
setroute set routing information for an XSCF network interface
setshutdowndelay set the shutdown wait time at power interruption of the
uninterruptible power supply (UPS)
setsmtp set up the Simple Mail Transfer Protocol (SMTP) settings
setsnmp manage the SNMP agent
To Next Page
Loading...
Need help?
General
