SunFounder PiCar-X Kit
2. Use the following command to install OpenSSH.Client.
Add-WindowsCapability -Online -Name OpenSSH.Client~~~~0.0.1.0
3. After installation, the following output will be returned.
Path :
Online : True
RestartNeeded : False
4. Verify the installation by using the following command.
Get-WindowsCapability -Online | Where-Object Name -like 'OpenSSH*'
5. It now tells you that OpenSSH.Client has been successfully installed.
Name : OpenSSH.Client~~~~0.0.1.0
State : Installed
Name : OpenSSH.Server~~~~0.0.1.0
State : NotPresent
Warning: If the above prompt does not appear, it means that your Windows system is still too
old, and you are advised to install a third-party SSH tool, like PuTTY.
6. Now restart PowerShell and continue to run it as administrator. At this point you will be able to log in to your
Raspberry Pi using the ssh command, where you will be prompted to enter the password you set up earlier.
170 Chapter 7. Appendix
To Next Page
Loading...
