SunFounder PiCar-X Kit - Faq; Q1: after Installing Ezblock OS, the Servo Cant Turn to 0

CHAPTER
EIGHT
FAQ
8.1 Q1: After installing Ezblock OS, the servo can’t turn to 0°?
1) Check if the servo cable is properly connected and if the Robot HAT power is on.
2) Press Reset button.
3) If you have already run the program in Ezblock Studio, the custom program for P11 is no longer available. You
can refer to the picture below to manually write a program in Ezblock Studio to set the servo angle to 0.
173