SunFounder PiCar-X Kit
8.2 Q2: When using VNC, I am prompted that the desktop cannot be
displayed at the moment?
In Terminal, type sudo raspi-config to change the resolution.
8.3 Q3: Why does the servo sometimes return to the middle position
for no reason?
When the servo is blocked by a structure or other object and cannot reach its intended position, the servo will enter the
power-off protection mode in order to prevent the servo from being burned out by too much current.
After a period of power failure, if no PWM signal is given to the servo, the servo will automatically return to its original
position.
8.4 Q4: About the Robot HAT Detailed Tutorial?
You can find a comprehensive tutorial about the Robot HAT here, including information on its hardware and API.
•
Note: Hello, welcome to the SunFounder Raspberry Pi & Arduino & ESP32 Enthusiasts Community on Facebook!
Dive deeper into Raspberry Pi, Arduino, and ESP32 with fellow enthusiasts.
Why Join?
• Expert Support: Solve post-sale issues and technical challenges with help from our community and team.
• Learn & Share: Exchange tips and tutorials to enhance your skills.
• Exclusive Previews: Get early access to new product announcements and sneak peeks.
• Special Discounts: Enjoy exclusive discounts on our newest products.
• Festive Promotions and Giveaways: Take part in giveaways and holiday promotions.
Ready to explore and create with us? Click [] and join today!
174 Chapter 8. FAQ
To Next Page
Loading...