Chapter 1: Introduction
1-19
Features of the P6DBS, P6DBE, P6DBU, P6SBU, P6SBS,
P6SBA and P6SBM Motherboards
CPU
• Celeron SEPP 266-433 MHz or dual Pentium II 233-333 MHz at 66 MHz
bus speed or dual Pentium II 350-450 MHz or dual Pentium III proces-
sors at 100 MHz bus speed (Note: The P6SBU, P6SBS, P6SBA and P6SBM support
a single processor only.) (Also see note on processors - page 2-3.) (*Note: Currently, the
P6DBE/P6DBU/P6SBU/P6SBA motherboard supports CPU speeds up to 1GHz with 100 MHz
FSB speed.)
Memory
• Maximum of 1 GB EDO at 66 MHz or 512 MB unbuffered 3.3V SDRAM,
or 1 GB registered SDRAM (P6DBS/P6DBE/P6DBU/P6SBU/P6SBS only)
• 768 MB EDO, 768 MB registered DIMM or 384 MB SDRAM (P6SBA and
P6SBM only)
(Note: When the CPU bus is running at 100 MHz, the SDRAM must be PC-100 compliant
DIMMs.)
(Note: The maximum cacheable memory size depends on the processor capabilities.)
• ECC and non-ECC memory supported
Chipset
• Intel 440BX
Expansion Slots
P6DBS/P6SBU/P6SBS/P6SBA P6DBU/P6DBE P6SBM
• 4 PCI slots • 5 PCI slots • 3 PCI slots
• 3 ISA slots • 2 ISA slots • 1 ISA slot
One shared PCI/ISA slot
• 1 AGP slot • 1 AGP slot • 1 AGP slot
BIOS
• 2 Mb AMI
®
Flash BIOS
• APM 1.2, DMI 2.1, Plug and Play (PnP)
• Adaptec 7890 SCSI BIOS (P6DBU/P6SBU only)
• Adaptec 7895 SCSI BIOS (P6DBS/P6SBS only)
PC Health Monitoring
• Seven onboard voltage monitors for CPU core(s), CPU I/O, +3.3V, ±5V
and ±12V
• Three-fan status monitors with firmware/software on/off control
• Environmental temperature monitor and control
• CPU fan auto-off in sleep mode
• Chassis overheat alarm, LED and control
• Chassis intrusion detection
To Next Page
Loading...
