Chapter 4: AMI BIOS
4-43
may be required for long and busy lines. The options are 9600, 19200,
38400, 57600, and 115200 (bits per second).
Data Bits
Use this feature to set the data transmission size for Console Redirec-
tion. The options are 7 (Bits) and 8 (Bits).
Parity
A parity bit can be sent along with regular data bits to detect data
transmission errors. Select Even if the parity bit is set to 0, and the
number of 1's in data bits is even. Select Odd if the parity bit is set
to 0, and the number of 1's in data bits is odd. Select None if you
do not want to send a parity bit with your data bits in transmission.
Select Mark to add a mark as a parity bit to be sent along with the
data bits. Select Space to add a Space as a parity bit to be sent with
your data bits. The options are None, Even, Odd, Mark, and Space.
Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit
for standard serial data communication. Select 2 Stop Bits if slower
devices are used. The options are 1 and 2.
Flow Control
Use this item to set the ow control for Console Redirection to pre-
vent data loss caused by buffer overow. Send a "Stop" signal to stop
sending data when the receiving buffer is full. Send a "Start" signal
to start sending data when the receiving buffer is empty. The options
are None and Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Select Enabled to enable VT-UTF8 Combination Key support for ANSI/
VT100 terminals. The default is Checked (Enabled).
Recorder Mode
Select Enabled to capture the data displayed on a terminal and send
it as text messages to a remote server. The default is Unchecked
(Disabled).
Resolution 100x31
Select Enabled for extended-terminal resolution support. The default
is Unchecked (Disabled).
To Next Page
Loading...
Need help?
General
