© Copyright Mission Critical Energy Inc, 2019 Version 1-2019
www.superwind.com
The trailing edges of the rotor blades are very thin and sharp. Use caution
when unpacking, both to avoid injury and damage to the blades.
5.2 Tools
A set of Allen wrenches is supplied to assist with the installation of your Superwind
350/48V.
The following additional tools will also be required:
Screw drivers
Set of wrenches
Wire strippers
Wire crimpers
Heat shrink or electrical tape
Multi-meter
Torque wrench
Tools for the mast installation are not listed here. Refer to applicable mast installation
instructions.
5.3 Available accessories
Mast-Sets:
Mast kit for guyed tubular mast 6 m (19.68 FT) [other heights on request]
Mast kit for self-supporting tubular mast 7.5 m (24.60 FT).
5.4 Electrical Components:
Superwind SCR 48V Charge Regulator with diversion load power resistor
10 amp slow-blow fuse and holder
Stop-switch
Temperature Sensor
To Next Page
Loading...
