9 Initial commissioning
9.1 Checking the hardware installation
Warning:
Before connecting the power supply to the device, check the supply voltage with respect
to the data plate and compare them.
Check the wiring of the device with respect to the wiring diagram.
9.2 Basic settings of the equipment
Firstly, set the display language for the various menus.
Note that the BASIC SETTING submenu is accessible only after you have entered the Level 3
code, see CODES paragraph.
Refer to the specific paragraphs, using the contents, to define the read and displayed parameters,
as well as the entire configuration of the controller, analog outputs, etc.
To Next Page
Loading...