1.4 Electrical connection
Warning:
Only use the power supply specified on the nameplate to run the S200 measurement and
monitoring device!
The device is delivered to run, by default, on a 230V/50Hz or 110V/50Hz power supply.
1.5 Safety Instructions
S200 Open measuring and monitoring devices are manufactured and tested according to
standards DIN EN 61010-1 / VDE 0411-1. This device left the factory in good condition. In
order to maintain this condition, and to ensure the safety during use, the user must comply
with the information and warnings given in this manual. If it is suspected that operating in total
safety is no longer possible, we recommend that you turn off the device and disable it to
prevent any accidental operation.
Follow these instructions:
- if the system shows visible signs of deterioration
- if the system is apparently no longer operational
- after an extended period of storage under poor conditions.
1.6 Damage due to transport
We carefully pack the S200 Open measuring and monitoring devices for transport. Please
check that the content of the delivery is complete and in good condition. Any damage due to
transport must be reported immediately (carrier).
The device must never be exposed to temperatures outside the range of -20 to +70°C
(transport and intermediate storage).
Subject to technical amendments. Subject to changing the assembly of components.
To Next Page
Loading...