10 Maintenance and servicing
10.1 General overview
Be sure to use only a damp cloth to clean the casing. The use of strong, caustic or abrasive
cleaning agents (acid cleaners, etc.) is not recommended!
The S200 measurement and monitoring device is easy to service, but ensure that a qualified
technician checks it and performs maintenance at regular intervals.
Please contact us for any other questions regarding our measurement, monitoring and metering
system.
10.2 Cleaning and calibration of probes
Depending on the water quality, the probes should be cleaned at intervals of 1 to 6 months (or
sooner if required). Calibration is required according to the type of probe.
Warning:
Disable the metering function before removing the probes.
To Next Page
Loading...