Surron HYPER BEE - Feature Introduction; Handlebar Controls

Feature introduction
A. Magnetic Cut-off Switch
When the vehicle is in READY condition, removing the
Magnetic cut-off switch will cut off the power output of
the vehicle.
B. Horn Button
The horn can be used to warn vehicles around you or any
other individuals present.
C. SET Button
This button is used for setting system features and
switching the display of the dashboard menu.
D. READY Button
This button is a button with three operational functions.
READY MODE: When the motorcycle is powered on,
pressing the button enables your motorcycle to be
ridden.
REVERSE MODE: When the READY indicator is illuminated
and the throttle is in the fully closed position，the
motorcycle is stopped， press and hold the READY
button， the reverse indicator R on the dashboard will
illuminate. Rotating the throttle will cause your Hyper
Bee to move backwards. Only when the READY button is
released and the throttle is returned to the fully closed
position, and the motorcycle is stopped will your
motorcycle exit REVERSE MODE and return to the normal
riding direction. NOTE: The motorcycle will vibrate
6.1
6.2
slightly as a reminder when entering or exiting reverse
mode.
FEATURE SELECT: After entering the system feature
mode, you can use the READY button to select the
options within any feature. For more details, see page
5.1.
E.Brake Lever Adjuster
Adjustment knob is used to adjust the brake lever
position to fit the rider's preference.
F.Rear Brake Lever
When you pull or squeeze the brake lever， it will
progressively control the rear brake system. When
braking， the throttle should be in the idle position.
G.Front Brake Lever
When you pull or squeeze the brake lever， it will
progressively control the front brake system. When
braking， the throttle should be in the idle position.
H.Throttle Control
When the motorcycle is in READY state, twisting the
throttle in a counterclockwise rotation starts the motor
and accelerates the motorcycle in a forward direction.
Release the throttle and it snaps back to the idle position
will stop powering the motor, remove the magnetic cut-
off switch thus decelerating the motorcycle. The throttle
sensitivity level can be adjusted in the System Feature
Mode.
Handlebar controls
DC
E
F
BA
E H
G
_ _ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
The Hyper Bee electric motorcycle is not equipped
with a brake override function, please use braking
force cautiously to avoid any injuries
Feature introduction