EasyManua.ls Logo

Surron HYPER BEE - Ride the Hyper Bee Electric Motorcycle; Front Fork Adjustment

Default Icon
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ride the Hyper Bee Electric Motorcycle
Starting
Turn the key switch from OFF position to the ON position.
Confirm the battery’s displayed SoC percentage is
suitable for your planned ride.
Reinstall the magnetic cap of the magnetic cutoff switch.
After confirming there are no obstacles or passing
vehicles in surrounding area, lift the side stand, press
the READY button on the left combination to enter the
READY mode (the READY indicator on the dashboard will
light up) and twist throttle to increase the speed and
begin your ride.
Braking
The brake levers are located on the left and right
handlebars.
When you pull the right brake lever, it controls the front
brake.
When you pull the left brake lever, it controls the rear
brake.
Parking
Reset the throttle to idle position, remove the magnetic
cap from the magnetic cut-off switch.
Put side stand down to prevent your motorcycle from
falling over.
Turn the key switch to the OFF position and remove the
key, and keep it in a safe place.
Front Fork Adjustment
Rebound damping
Turning the adjusting knob A clockwise in the "+"
direction increases the rebound damping, resulting in a
slower rebound speed.
Turn the adjusting knob A counterclockwise in the "-"
direction decreases the rebound damping, resulting in a
faster rebound speed
7.3
7.4
_ _ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
The appearance of front fork may vary based on
different brands supplied with your Hyper Bee,
please refer to the actual product
The rebound damping should be adjusted according
to the road conditions and the weight of the rider.
Avoid adjusting the damping to the maximum
limit, otherwise it may cause the front fork to
malfunction resulting in an accident and/or serious
injury
A
can cause the wheels to lock. This may result in you
losing control of the Hyper Bee electric motorcycle
and could lead to serious injury or death
Progressively applying force to the brake levers
will gradually stop the electric motorcycle without
locking the wheels. Your Hyper Bee electric
motorcycle is a powerful vehicle, so it is strongly
recommended that you practice and get familiar
with performing a safe emergency stop
_ _ _ _ _ _ _ _ _ _ W A R N I N G _ _ _ _ _ _ _ _ _ _
If enough force is suddenly applied to the brakes, it
_ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
After each ride, please check the battery level and
charge the battery pack as necessary
Starting and Operating Starting and Operating

Related product manuals