Keep your Hyper Bee in safe condition. Use only Surron
approved parts and Surron Motorcycles accessories.
Maintaining your Hyper Bee properly is critical to your
safety. A loose bolt, for example, can cause a breakdown
in which you can be seriously injured. Only operate the
vehicle when it is in perfect technical condition, in
accordance with its intended use, and in a safe and
environmentally compatible manner.
Your motorcycle is a high voltage electric motorcycle,
follow the safety and caution instruction that apply when
using an electric motor. If you smell an unusual odor
coming from the lithium-ion (Li-Ion) battery or controller,
park your Hyper Bee in a safe place outside and away
from flammable objects, then turn off the key switch.
Contact your Authorized Surron Dealer to help you to
inspect your Hyper Bee immediately.
The rear brake lever is located on the left side of the
handlebar. Because this electric motorcycle does not
have a manual transmission, there is no clutch and gear
shifting.
Modifying a Hyper Bee electric motorcycle may make it
unsafe and may cause serious injury to yourself or
others. Surron is not responsible for any unauthorized
modifications.
Do not load heavy or large objects or adds-on
accessories on the Hyper Bee electric motorcycle. Large,
bulky items can adversely affect the safety and
performance of your Hyper Bee electric motorcycle
Important Information
Several important operational considerations are listed
below:
Always turn the key switch(A) to the OFF position and
remove the magnetic cut-off switch (B) when not actively
riding. It is extremely easy to forget that the motorcycle
is still in Ready mode because it is completely silent. An
accident might occur if the motorcycle is left powered up
and the throttle is inadvertently twisted.
Remove the magnetic cut-off switch and make sure the
READY indicator is extinguished when pushing or moving
the motorcycle.
Use the brakes when you are stopped on a ramp or steep
hill. Do not hold partial throttle to keep the motorcycle
stationary on a ramp or steep hill, it can trigger the
locked rotor protection, cutting the power to the motor
which could cause the motorcycle to move unexpectedly.
2.2
2.3
A rechargeable Lithium-ion battery is installed in the
motorcycle. The battery pack are located in front of the
seat, please recharge the battery pack of your electric
motorcycle after each use. Once fully charged,
disconnect from AC power supply. Make sure that the
charging is carried out in a safe and open space or with
monitoring.
When unplugged the battery power plug while the key
in the OFF position, the motorcycles electronic
components will consume a small amount of power, and
the battery pack will drain extremely slowly. If you don’t
ride for a long-term period of time (30 days or more),
you may need to charge the electric motorcycle for a few
hours prior to your next ride. The battery pack will be
damaged if it is stored for a long time under low power.
The battery pack does not require nor benefit from deep
discharging. To get the most battery pack lifecycle,
recharge the battery pack after each ride. Constantly
leaving the battery pack in a deep discharging state will
damage the battery cell.
Failure to follow instructions of battery pack storage and
charging as written in this manual may void the
warranty of your Hyper Bee electric motorcycle. These
guidelines have been rigorously tested to ensure
maximum battery pack efficiency and service. Note: The
battery pack contains components and elements that
might harmful the environment, please dispose the
battery pack properly and in compliance with the
applicable regulations. Never throw the battery into the
household trash bin.
___ ___ ___ __ _ __ CAU TIO N__ ___ __ _ __ ___
Only charge the Hyper Bee lithium-ion battery
pack with the motorcycle’s original charger or the
Surron approved charger. Only use the battery
pack while it is inside the motorcycle
Safety Information Safety Information
To Next Page
Loading...
