Surron HYPER BEE - Setting the Motorcycle Power Mode; Magnetic Cut-Off Switch Detachment Alert

_ _ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
Power mode of the Hyper Bee are only adjustable
within 3 minutes of powering on the motorcycle
while it is stationary. Hyper Bee Power mode
cannot be changed while riding or when the
motorcycle is in READY mode
6.9 6.10
Feature introduction Feature introduction
Setting the Motorcycle Power Mode:
After successfully connecting the Hyper Bee Remote to
the vehicle, and within 3 minutes of powering on the
motorcycle while it is stationary, you can switch between
the three power mode levels using the Hyper Bee
Remote.
Press and hold the volume "+" button on the Hyper Bee
Remote for 2 seconds to rise the power mode level. Press
and hold the volume "-" button on the Hyper Bee Remote
for 2 seconds to lower the power mode level:
-When Level 1 is set, one POWER indicator light on the
Hyper Bee Remote will remain lit, and a voice prompt
will announce "Power Level 1." The dashboard will
display one power bar and the number “1”.
-When Level 2 is set, two POWER indicator lights on the
Hyper Bee Remote will remain lit, and a voice prompt
will announce "Power Level 2." The dashboard will
display two power bars and the number “2”.
-When Level 3 is set, three POWER indicator lights on the
Hyper Bee Remote will remain lit, and a voice prompt
will announce "Power Level 3." The dashboard will
display three power bars and the number “3”.
Magnetic cut-off Switch Detachment Alert:
If the magnetic cut-off switch detaches while the vehicle
is in motion, the Hyper Bee Remote will emit a continuous
alarm sound.