Light Replacement
When the headlight A is damaged， please contact the
Authorized Surron Dealer for a complete replacement.
Motorcycle Cleaning
1. Use a sponge or clean soft cloth, neutral detergent
and water to gently clean the motorcycle.
2. Be extremely careful when cleaning the dashboard, it
is easy to get scratched.
3. After cleaning, rinse the motorcycle thoroughly with
water to remove all detergent residues.
4. Dry the motorcycle with a soft dry towel.
5. After cleaning, please check the motorcycle carefully
for anomalies.
After cleaning the motorcycle, please maintain the chain
and other parts that need to be lubricated. Please let all
electrical components completely dry before operation.
If the Hyper Bee electric motorcycle is to be ridden
immediately after cleaning, use the brakes several times
at a safe and low speed to remove the water or other
objects on the brake pads.
10.11
10.12
Wheel and Tire Cleaning
Avoid using strong acid wheel cleaners. If you use this
type of product to clean stubborn dirt, please rinse
quickly and dry it immediately to prevent damage.
Long-term Storage
For motorcycle that are not used for a long time (more
than 30 days), it is recommended to maintain the
battery level to about 60% to 80% and turn off the main
power switch of Hyper Bee electric motorcycle.
The battery pack also discharges slowly when stored.
Check the level of the battery pack at least once every
month. If the battery Soc level drops below 30%, then it
should be recharged to 60% to 80%. When you are ready
to use the Hyper Bee electric motorcycle again, please
fully charge the battery pack to ensure it is restored to
its best condition.
In order to extend the service life of the power system,
the Hyper Bee electric motorcycle should be stored in a
cool and ventilated place. Storing the Hyper Bee electric
motorcycle in a hot or humid place will shorten the life
span of the battery pack and electrical system. For more
information about batteries and electrical systems,
_____________CAUTION_____________
Improper cleaning can damage motorcycle parts.
Do not use a pressure washerhigh-pressure water
gun to flush bearings, seals, electrical components
and plugs. In order to extend the service life of
the Hyper Bee electric motorcycle, it should be
cleaned and maintained regularly, and it is
recommended to wipe it dry as soon as possible
after cleaning
Do not use any harsh chemical products on plastic
parts. Avoid cloths or sponges that have been in
contact with strong corrosive detergents, solvents,
thinners, fuels (gasoline), rust removers or
inhibitors, brake fluid, antifreeze, or electrolytes
_____________CAUTION_____________
Tires only need to be cleaned. Any tire maintenance
products may reduce the friction between the tire
and the ground, and even lead to premature
aging of the tire
Maintenance Maintenance
_____________WARNING_____________
Please make sure the dust cap is well placed
during the cleaning process to avoid exposing
the magnetic connector to the air or water, to
prevent damage to the vehicle's electrical and
power systems!
_____________WARNING_____________
After cleaning and before starting to ride, make
sure the brakes system functions properly
To Next Page
Loading...
