After the vehicle's power output is turned Off, the
dashboard will display the "NO AL" indicator.
Turn off the vehicle's key switch and turn it back on, and
the "NO" symbol will disappear, restoring the vehicle's
power to normal.
E. Hyper Bee Remote MIC Button
When the Hyper Bee Remote is properly connected to the
vehicle, press the "MIC" button on the Hyper Bee Remote
to start intercom communication. The vehicle's speaker
will play the intercom voice from the Hyper Bee Remote.
Release the button to end the intercom.
Quickly press the "MIC" button three times in succession
to turn on the vehicle dashboard microphone, allowing
voice to be transmitted back to the Hyper Bee Remote in
real-time. Repeat this operation to turn off the vehicle
microphone (the microphone is off by default each time
the motorcycle is powered on).
Entering Pairing Mode:-Power on the vehicle and ensure
the Hyper Bee Remote is next to the vehicle.-
Simultaneously press and hold the SET button and the
READY button on the left combination switch for more
than 2 seconds to access to the system feature mode.-
Short press the SET button to navigate through the
system feature mode until the display shows "T0."-Short
press the READY button; the display will change from
"T0" to "T1" and begin to flash.
While the Hyper Bee Remote is turned off, long press the
power button and hold until Connection Status Indicator
flashing blue light. The Hyper Bee Remote will play
audio to remind the user that the remote is in Motorcycle
pairing mode.
At this point, wait for the "T1" on the display to change
from flashing to a steady state. The Hyper Bee Remote
will audibly confirm successful pairing, and the
Connection Status Indicator will illuminate solid green
light, indicating that the Hyper Bee Remote and vehicle
have been successfully paired. Upon successful pairing,
both the motorcycle and the Hyper Bee Remote will
automatically exit pairing mode.
6.7 6.8
_ _ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
Once the Hyper Bee Remote is successfully paired
with the motorcycle for the first time, subsequent
pairing is not required. They will automatically
connect when both powered on and are within range
Entering Pairing Mode:
Power on the vehicle and ensure the Hyper Bee Remote
is next to the vehicle.-Simultaneously press and hold the
SET button and t h e READY but ton on the lef t
combination switch for more than 2 seconds to access to
the system feature mode.-Short press the SET button to
navigate through the system feature mode until the
display shows "T0."-Short press the READY button; the
display will change from "T0" to "T1" and begin to flash.
While the Hyper Bee Remote is turned off, long press the
power button and hold until Connection Status Indicator
flashing blue light. The Hyper Bee Remote will play
audio to remind the user that the remote is in Motorcycle
pairing mode.
At this point, wait for the "T1" on the display to change
from flashing to a steady state. The Hyper Bee Remote
will audibly confirm successful pairing, and the
Connection Status Indicator will illuminate solid green
light, indicating that the Hyper Bee Remote and vehicle
have been successfully paired. Upon successful pairing,
both the motorcycle and the Hyper Bee Remote will
automatically exit pairing mode.
Feature introduction Feature introduction
_ _ _ _ _ _ _ _ _ _ _ _ _ N O T E _ _ _ _ _ _ _ _ _ _ _ _ _
The maximum connection distance of the vehicle and
the juvenile bee remote controller is 300 meters. This
distance may be shortened due to factors such as
weather, environment, and obstacles
To Next Page
Loading...
