WARNING: When diving with multiple gases, remember that the ascent time is always
calculated with the assumption that you use all the gases found in the Gases menu. Always
check that you have only the gases for your current planned dive
defined before you dive.
Remove the gases that are not available for the dive.
WARNING: YOUR ACTUAL ASCENT TIME MAY BE LONGER THAN DISPLAYED BY THE
DIVE COMPUTER! The ascent time will increase if you: (1) remain at depth, (2) ascend slower
than 10 m/min (33 ft/ min), (3) make your decompression stop deeper than at the ceiling,
and/or (4) forget to change the used gas mixture. These factors might also increase the
amount of breathing gas required to reach the surface.
3.10.1. Last stop depth
You can adjust the last stop depth for decompression dives under Dive settings »
Parameters » Last stop depth. There are two options 3 and 6 m (10 and 20 ft).
By default, the last stop depth is 3 m (10 ft). This is the recommended last stop depth.
NOTE: This setting does not aect the ceiling depth on a decompression dive. The last
ceiling depth is always 3 m (10 ft).
3.11. Device info
Information about your Suunto D5 can be found in your device. This information includes
device name, serial number, device history, software and hardware versions and radio
compliance information. See 4.1. How to access device info.
3.12. Display
Display LED backlight is on by default.
You can
significantly extend battery life by turning down the display brightness when there is
ambient light available. The display is still easily readable.
For display brightness adjustment, see 4.2. How to change display brightness.
3.13. Dive history
Dive history is a summary of all the dives done with your Suunto D5. The history is divided
according to the dive mode used for the dive. Each dive type summary includes the number
of dives, cumulative dive hours and maximum depth reached in all dives of that dive mode.
Enter History under General » About D5:
Suunto D5
25
To Next Page
Loading...
