Suzuki DL1000 Service Manual

FI SYSTEM 4-61
• Disconnect the throttle cables from their drum.
• Dismount the throttle body assembly.
"
THROTTLE BODY DISASSEMBLY
• Remove the IAP sensor vacuum damper and its hose.
• Remove the throttle link rod
1 and secondary throttle link rod
2.
NOTE:
The throttle link rod
1 is longer than the secondary throttle link
rod
2.
• Remove the fuel delivery pipe.
* Be careful not to damage the throttle cable bracket
and fast idle lever when dismounting or remounting
the throttle body assembly.
* After disconnecting the throttle cables, do not snap
the throttle valve from full open to full close. It may
cause damage to the throttle valve and throttle body.

Suzuki DL1000 Specifications

General

Displacement	996cc
Compression Ratio	11.3:1
Final Drive	Chain
Starter	Electric
Bore x Stroke	98.0mm x 66.0mm
Transmission	6-speed
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Fuel Tank Capacity	22.0 L (5.8 US gal)
Ground Clearance	165 mm (6.5 in)
Ignition	Electronic
Fuel System	Electronic Fuel Injection