4-76 FI SYSTEM
ECT SENSOR INSPECTION
The engine coolant temperature sensor is installed on the ther-
mostat case. (#4-38 and 5-10)
ECT SENSOR REMOVAL/INSTALLATION
(#5-10)
AP SENSOR INSPECTION
The atmospheric pressure sensor is located under the seat.
(#4-40)
AP SENSOR REMOVAL/INSTALLATION
• Remove the seat. (# 6-4)
• Disconnect the coupler
1 and remove the AP sensor.
• Installation is in the reverse order of removal.
TO SENSOR INSPECTION
The tip over sensor is located above the AP sensor. (#4-42)
TO SENSOR REMOVAL/INSTALLATION
• Remove the seat. (# 6-4)
• Disconnect the coupler
1 and remove the TO sensor.
• Installation is in the reverse order of removal.
NOTE:
When installing the TO sensor, bring the “UPPER” letter on it to
the top.
HO2 SENSOR INSPECTION
The heated oxygen sensor is installed on the exhaust pipe.
(#4-49)
To Next Page
Loading...
