Suzuki DL1000 - Rear Piston Service; Engine Bottom Side Disassembly; Oil Filter and Pump Service

ENGINE 3-25
• Remove the cylinder base gasket and dowel pins.
REAR PISTON
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlip into the crankcase.
• Remove the piston pin circlip.
• Remove the piston by driving out the piston pin.
NOTE:
Scribe the cylinder number on the head of the piston.
ENGINE BOTTOM SIDE
OIL FILTER
• Remove the oil filter with the special tool.
" 09915-40610: Oil filter wrench
• Remove the generator cover.
• Remove the starter torque limiter
1 and starter idle gear 2.