CHASSIS 6-75
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble and remount the master cylinder in the reverse
order of removal and disassembly. Pay attention to the following
points:
"
, Specification and Classification: DOT 4
• Apply brake fluid to the piston/cup set.
• Install the following parts.
1 Spring
2 Piston/primary cup
3 Push rod
4 Snap ring
5 Dust boot
• Apply the SUZUKI MOLY PASTE to the push rod.
. 99000-25140: SUZUKI MOLY PASTE
• Install the O-ring
6, connector
7 and snap ring
8 to the
master cylinder.
"
• Install the master cylinder.
• Tighten the lock nut
9.
& Rear master cylinder rod lock nut:
18 N·m (1.8 kgf-m, 13.0 lb-ft)
* Wash the master cylinder components with fresh
brake fluid before reassembly. Never use cleaning
solvent or gasoline to wash them.
* Do not wipe the components with a rag.
* Apply brake fluid to the cylinder bore and all the
component to be inserted into the bore.
Replace the removed O-ring with a new one.
To Next Page
Loading...
