ENGINE 3-27
$ Valve spring tension (IN. & EX.)
Standard INNER: 76 – 90 N/32.5 mm
(7.8 – 9.2 kgf/32.5 mm, 17.2 – 20.3 lbs/1.28 in)
OUTER: 186 – 219 N/36.0 mm
(18.9 – 22.3 kgf/36.0 mm, 41.7 – 49.2 lbs/1.42 in)
REASSEMBLY
Reassemble the cylinder head in the reverse order of disassem-
bly. Pay attention to the following points:
• Install each valve spring seat
1.
• Apply molybdenum oil solution to the valve stem seal, and
press-fit the seal into position by hand.
#
( MOLYBDENUM OIL
• Apply molybdenum oil solution to the valve stems.
#
( MOLYBDENUM OIL
• Install the valve springs with the smaller pitch
A facing the
cylinder head.
Do not reuse the valve stem seals.
When inserting each valve, take care not to damage
the lip of the stem seal.
Towards
Cylinder
head
To Next Page
Loading...
