Suzuki DR-Z125L - Clutch

3-52 ENGINE
CLUTCH
• Install the washer
1 and spacer 2 onto the countershaft.
NOTE:
Apply engine oil to the inside and outside surfaces of the spacer.
• Install the primary driven gear assembly
3 and washer 4
onto the countershaft.
NOTE:
When engaging the primary drive and driven gears, turn the pri-
mary driven gear assembly to the counterclockwise.
• Install the clutch sleeve hub
5 and lock washer 6.
#
1 Primary driven gear assembly
2 Clutch sleeve hub
3 Clutch push rod
4 Clutch driven plate
5 Clutch drive plate
6 Push piece
7 Clutch pressure plate
ITEM N·m kgf-m lb-ft
A 50 5.0 36.0
@
Install the lock washer so that its tongue
A is aligned
with the flat portion of the clutch sleeve hub.