Suzuki DR-Z125L - Page 87

ENGINE 3-51
• Install each pawl into the gearshift cam driven gear.
1 Gearshift pawl
2 Pin
3 Spring
4 Gearshift cam driven gear
NOTE:
The large shoulder
A must face to the outside.
• Install the gearshift cam driven gear assembly.
• Install the pawl lifter
5 and cam guide 6.
NOTE:
Apply a small quantity of THREAD LOCK “1342” to the threads
of the screws.
+ 99000-32050: THREAD LOCK “1342”
GEARSHIFT SHAFT
• Install the return spring
1 to the gearshift shaft.
• Install the gearshift shaft.
NOTE:
Align the center teeth on the gearshift shaft with the center teeth
on the gearshift cam driven gear.
• Install the kick starter drive gear and washers.