COOLING AND LUBRICATION SYSTEM 7-15
• Install the rubber seal into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side # of mechanical seal ring faces the rub-
ber seal.
• Install the washer and seal washer onto the impeller
securing bolt .
NOTE:
The metal side $ of seal washer and the curved side % of
washer face the impeller securing bolt head.
• Install the impeller and its securing bolt onto the shaft.
• Tighten the impeller securing bolt to the specified torque.
" Impeller securing bolt: 8 N·m (0.8 kgf-m, 6.0 lb-ft)
NOTE:
Before installing the impeller securing bolt, apply a small quan-
tity of the thread lock to it.
H99000-32110: THREAD LOCK SUPER “1322”
or equivalent
• Install the new O-rings and .
NOTE:
* Apply engine coolant to the O-ring .
* Apply grease to the O-ring .
X 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Tighten the water pump cover screws to the specified torque.
" Water pump cover screw: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
NOTE:
Fit the clamp & to the water pump cover screw.
Use the new O-rings to prevent engine coolant leak-
age.
To Next Page
Loading...
