Suzuki Intruder VL800 User Manual

VL800/C/TK9 (’09-MODEL) 18-55
THROTTLE VALVE SYNCHRONIZATION
USE OF SDS TOOL
Check and adjust the throttle valve synchronization between two
cylinders.
Step 1
• Lift and support the fuel tank. ( Page 14-93)
• Disconnect the vacuum hoses 1 from the throttle body.
• Connect the respective vacuum tester hoses and IAP sensor
vacuum hoses to each vacuum nipple on the throttle body
with the tools (A, B).
13681-39F00-225: Hose A
13685-02FA0: Three way joint B
Step 2
• Temporary install the fuel tank.
• Set up the SDS tool. (Refer to the SDS operation manual for
further details.)
 09904-41010: SDS set tool
99565-01010-017: CD-ROM Ver.17
• Start the engine.
• Click “Data monitor”.
• Warm up the engine (Water temp. more than 90 °C (194 °F)).

Suzuki Intruder VL800 Specifications

General

Engine Type	4-stroke, liquid-cooled, SOHC, 45-degree V-twin
Displacement	805cc
Bore x Stroke	83.0 mm x 74.4 mm
Compression Ratio	9.4:1
Fuel System	Fuel injection
Ignition	Electronic ignition (Transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Disc brake
Rear Brakes	Drum brake
Front Tire	130/90-16M/C 67H
Rear Tire	170/80-15M/C 77H
Overall Height	1, 105mm (43.5 inches)
Wheelbase	1, 655 mm
Ground Clearance	140mm (5.5 inches)
Seat Height	700 mm (27.6 in)