Suzuki Intruder VL800 User Manual

ENGINE 3-45
STARTER CLUTCH SERVICING
• Hold the rotor with off-set wrench and remove the starter clutch
securing bolts.
• When fitting the one way clutch to the guide 1, position flange
side A of one way clutch to the rotor side.
• Apply THREAD LOCK SUPER “1303” to the securing bolts and
tighten them to the specified torque while holding the rotor with
off-set wrench.
'99000-32030: THREAD LOCK SUPER “1303”
# Starter clutch securing bolt: 26 N
.
m (2.6 kgf
.
m, 19.0 lb-ft)
OIL PUMP
• Rotate the oil pump by hand and check that it moves smoothly.
• If it does not move smoothly, replace the oil pump assembly.
Do not attempt to disassemble the oil pump assembly.
The oil pump is available only as an assembly.

Suzuki Intruder VL800 Specifications

General

Engine Type	4-stroke, liquid-cooled, SOHC, 45-degree V-twin
Displacement	805cc
Bore x Stroke	83.0 mm x 74.4 mm
Compression Ratio	9.4:1
Fuel System	Fuel injection
Ignition	Electronic ignition (Transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Disc brake
Rear Brakes	Drum brake
Front Tire	130/90-16M/C 67H
Rear Tire	170/80-15M/C 77H
Overall Height	1, 105mm (43.5 inches)
Wheelbase	1, 655 mm
Ground Clearance	140mm (5.5 inches)
Seat Height	700 mm (27.6 in)