SHAFT DRIVE 4-4
REASSEMBLY
Reassemble the secondary bevel gears in the reverse order of disassembly and also carry out the following
steps:
NOTE:
Before reassembly, thoroughly clean all parts in cleaning solvent.
_
l
Apply grease to the
lip of oil seal and O-ring.
(For U.S.A. model)
nnnnn
‘)cn3tl .
YYUUU-LcJU3U .
CI ,7I IV,
Cl
IL)CD
PDCACC “A”
J”L”lNl3”rL” ““Lr\3L
(For the other models)
_
99000-25010
:
SUZUKI SUPER GREASE “A”
CAUTION:
Always use a new oil seal and O-ring.
0 Tighten the bearing retainer to the specified torque.
Tightening torque : 90 - 120 N-m
(9.0 - 12.0 kg-m, 65.0 - 87.0 lb-ft)
09921-21820
:
Bearing retainer wrench
SECONDARY GEARS SHIM ADJUSTMENT
BACi(ip-eii
l
Install the secondary drive bevel gear assembly and removed
shims, and tighten the three bolts @ to the specified torque.
Tightening torque
:
18 - 28 N-m
(1.8 - 2.8 kg-m, 13.0 - 20.0 lb-ft)
To Next Page
