Swann AMI Oxytrace - Page 88

86 A-96.250.531 / 300617
AMI Oxytrace QED
Program List and Explanations
5.3.4.3 Output/Control: (relay or signal output):
5.3.4.4 Fault:
5.3.4.5 Delay: Time which the instrument waits, after the input is deactivat-
ed, before returning to normal operation.
Range: 0–6‘000 Sec
Cont.: Controller continues normally.
Hold: Controller continues on the last valid value.
Off: Controller is switched off.
No: No message is issued in pending error list and
the alarm relay does not close when input is
active. Message E024 is stored in the message
list.
Yes: Message E024 is issued and stored in the mes-
sage list. The Alarm relay closes when input is
active.