Swann AMI Powercon - Page 73

AMI Powercon
Program List and Explanations
A-96.250.341 / 061015 71
2.2.2 Miscellaneous:
2.2.2.1 Case Temp: Shows the current temperature in [°C] inside the trans-
mitter.
2.3 Sample
2.3.1 Sample ID: Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Temperature: Shows the current sample temperature in °C.
(Pt 1000): Shows the current temperature in Ohm.
Sample Flow: Shows the current sample flow in l/h and the Raw
Value in Hz.
The Sample flow must be above 5 l/h.
2.4 I/O State
Shows current status of all in- and outputs.
2.4.1/2.4.2
2.5 Interface
Only available if optional interface is installed.
Review programmed communication settings.
Alarm Relay:
Open or closed.
Relay 1 and 2:
Open or closed.
Input:
Open or closed.
Signal Output 1 and 2:
Actual current in mA
Signal Output 3:
Actual current in mA (if option is installed)